Indian Society for Heat and Mass Transfer

ライブラリ登録: Guest
ホーム アーカイブ 役員 今後の会合
Proceedings of the 24th National and 2nd International ISHMT-ASTFE Heat and Mass Transfer Conference (IHMTC-2017)

ISSN: 2688-7231 (Online)


P. Srikrishna
MTRDC, DRDO, Bangalore

A R Hari Kumar
Indian Institute of Science, Bangalore

Dr SUM Reddy
MTRDC, DRDO, Bangalore

G.S.V.L. Narasimham
Department of Mechanical Engineering, Indian Institute of Science, Bangalore 560012, India

DOI: 10.1615/IHMTC-2017.1050
pages 747-752


Electronic devices are shrinking in size while their performance is increasing. The increased functionality has resulted in higher heat loads whereas the reduced sizes have complicated the thermal management further by making the heat fluxes more severe. Hence commercially competitive and efficient thermal management techniques have gained large significance in the electronics industry.
The pulsating heat pipes (PHPs) have been researched due to their promise as effective heat transport devices. The PHPs being less complicated in their construction render themselves as more than suitable alternatives to the conventional heat pipes. Though PHPs have the perceived advantages, reliable data for their simulation, design and performance prediction has not been established [1-2]. In this work, a single closed loop PHP has been experimentally studied to ascertain the performance and operating characteristics.
A PHP with a single loop of 2.5 mm internal diameter and 190mm overall length was tested for evaporator down orientation for varying heat loads. The fill ratio maintained was around 50% by volume with methanol as the working fluid.
The overall steady state thermal resistance (Rth) was estimated from the experiment for various input heat loads up to 70 W. The start-up characteristic for each heat load was recorded as a temperature trace with respect to time. The thermal resistance of the heat pipe was found to reduce with increasing heat loads with 70 W having a resistance of 0.46 K/W and an evaporator temperature of 110°C. The start-up was almost instantaneous for the higher heat loads whereas the PHP barely initiated operation at 10 W.

購入する $25.00 Check subscription 出版倫理および不正行為 私の図書館員へ推薦 このページをブックマークする