用户登录 购物车
图书馆订购 Guest
主页 旧刊 有关人员 未来大会

ISSN 在线: 2688-7231

ISBN 在线: 978-1-56700-524-0

Proceedings of the 26thNational and 4th International ISHMT-ASTFE Heat and Mass Transfer Conference December 17-20, 2021, IIT Madras, Chennai-600036, Tamil Nadu, India
December, 17-20, 2021, IIT Madras, Chennai, India

Thermal Performance of a Closed-Loop Flat Plate Pulsating Heat Pipe Filled with Water-based Binary Mixtures

Get access DOI: 10.1615/IHMTC-2021.1210
pages 807-813

摘要

The thermal performance of a closed-loop flat plate pulsating heat pipe filled with water-based binary mixtures and the corresponding pure liquids as working fluid is investigated experimentally at a 60% filling ratio. The experiments are reported for the gravity-assisted mode. The evaporator section is at the bottom, the condenser section at the top, and in between a well-insulated adiabatic section. The evaporator section is heated using cartridge heaters, and the condenser section is maintained at 22°C. The flow regime inside the flat plate pulsating heat pipe is captured using a high-speed camera. The dry-thermal resistance is around 0.5 K/W (for all heat inputs). The thermal resistance (R) decreases with increased heat input (Qin) and volume percentage of ethanol in the binary mixture. The smallest measured resistance is 0.2 K/W for the case of pure ethanol at Qin = 160 W. The slug-plug oscillations and the flow frequency from the evaporator to condenser increase with the increase in Qin and %vol of ethanol. These phenomena are attributed to the relatively larger saturation pressure gradient versus temperature (dp/dT)sat and lower boiling point and surface tension for ethanol than water.
主页 旧刊 有关人员 未来大会 中文 English Русский Português 帮助 联系我们 返回至ISHMT