カスタマーログイン ショッピングカート
ライブラリ登録: Guest
ホーム アーカイブ 役員 今後の会合

ISSN オンライン: 2688-7231

ISBN 印刷: 978-1-56700-497-7 (Flash Drive)

ISBN オンライン: 978-1-56700-496-0

Proceedings of the 25th National and 3rd International ISHMT-ASTFE Heat and Mass Transfer Conference (IHMTC-2019)
December, 28-31, 2019, IIT Roorkee, Roorkee, India

Thermal performance of double pipe heat exchanger with V-cut twisted Tape inserts

Get access DOI: 10.1615/IHMTC-2019.600
pages 353-358

要約

In this paper, the effect of V-cut twisted tape inserts on heat transfer and friction factor characteristics in a double pipe heat exchanger have been experimentally investigated for three twist ratios (TR = 5, 10 and 15), different combinations of depth and width ratios (DR=1/2, WR=1/2; DR=1/3, WR=1/2; DR=1/2, WR=1/3) and inlet temperatures (50°C, 60°C and 70°C). Water has been used as hot fluid (flowing through in-tube side, where twisted tape inserts is used) as well as cold fluid (flowing through annulus side). The obtained results show that the Nusselt number increases and the friction factor decreases with increasing Reynolds number for the same twist ratio. The average Nusselt number and friction factor of water flowing in the inner tube with twisting ratios of 5, 10 and 15 for same depth and width ratio (DR=1/2 and WR=1/2) respectively, enhance 1.51 to 2.52, 1.37 to 2.03, 1.09 to 1.57 times and 1.55 to 1.87, 1.45 to 1.77 and 1.36 to 1.62 times respectively, that for the plain tube. Higher depth ratio (DR=1/2) and lower width ratio (WR=1/3) yield higher heat transfer and friction factor than those V-cuts twisted tape with lower depth ratio (DR=1/3) and higher width ratio (WR=1/2). The value of thermal performance factor (TPF) is greater than unity for all cases. This indicates that using V-cuts twisted tape inserts is considered a better choice in practical application.
ホーム アーカイブ 役員 今後の会合 English Русский 中文 Português ヘルプ 問合せ先 ISHMTへ戻る