カスタマーログイン ショッピングカート
ライブラリ登録: Guest
ホーム アーカイブ 役員 今後の会合

ISSN オンライン: 2688-7231

ISBN オンライン: 978-1-56700-524-0

Proceedings of the 26thNational and 4th International ISHMT-ASTFE Heat and Mass Transfer Conference December 17-20, 2021, IIT Madras, Chennai-600036, Tamil Nadu, India
December, 17-20, 2021, IIT Madras, Chennai, India

HEAT TRANSFER ENHANCEMENT OF AN IMPINGING SYNTHETIC AIR JET USING SHARP-EDGED ORIFICE

Get access DOI: 10.1615/IHMTC-2021.2770
pages 1835-1840

要約

Over the last few decades, extensive research is carrying out to encounter the cooling demand of high heat flux electronic instruments. Among the emerging cooling technologies, synthetic jet (SJ) proved to be an efficient and a compact candidate to meet the cooling demand of future electronics. SJ actuator is basically a novel Zero-net-mass-flux (ZNMF) device which allows momentum transport to the ejected fluid without any net mass transfer over an actuation cycle. The design of the orifice in SJ plays a significant role in the behavior of the ejected fluid from the orifice. Hence, the thermal performance of the SJ is found to be altered with the change in the orifice shapes. Here an experimental investigation of sharp-edged (diverging) orifices SJ has been carried out for half-opening angle of 30°, 45° and 60° having the same throat diameter equivalent to the circular orifice (d =15 mm). Experiments are performed at constant Reynold number, Re = 4062 by operating the acoustic actuator at 4 Vrms and 40 Hz. Results show that sharp-edged orifice with an half-opening angle of 30° and 45° provide an enhancement in heat transfer in comparison with circular orifice. Also, for higher surface spacing (z/d > 10), all the tested cases of diverging orifice exhibit higher thermal efficacy than the round orifice.
ホーム アーカイブ 役員 今後の会合 English Русский 中文 Português ヘルプ 問合せ先 ISHMTへ戻る